Outlaw SE FAQs
First, plug the battery into the Altair Outlaw SE and lock the battery into position with the twist lock feature. Once you hear the audible confirmation beeps, grab your controller for the next step. First, push the red button down on the top left side and then flip the on switch in the middle of your remote. You will hear one long beep and then two short beeps to confirm the Outlaw SE and the remote are now paired. On your LCD Screen, you will see bars indicating the connection status and the lights on your drone will be blinking alternatively from front to back. To see this in action, watch this video here
Make sure that you are outside and in and open space with a low amount of wind. Pair your remote according the the instructions and then compass calibrate the Outlaw SE horizontally and then vertically. When the lights are no longer blinking, you are able to unlock the propellers and fly the drone.
Please do not fly the Outlaw SE in windy conditions.
The flight range of the Outlaw SE is 600 meters.
The Outlaw SE weighs approximately 2.8 pounds
The dimensions of the Outlaw SE are 16.5 x 11.3 x 5.2 inches
A 7.4V 1800 mAh Li-polymer battery is included with the Altair Outlaw SE
The battery on the Outlaw SE lasts about 18-20 minutes
A full recharge will take around 5 hours
Installing replacement propellers correclty is extremely important to safely continue to fly your Altair Outlaw SE. Make sure to only replace one propeller at a time and to only replace "A" propellers with "A" replacement propeller and "B" propellers with "B" replacement propellers. For more help with propeller installation, please watch this video
Yes! The Altair Outlaw SE has a built in, 1080p HD Camera.
No. The Outlaw SE is rated for ages 14 and up and should only be flown by experienced pilots. Once familiar with the Outlaw SE controls, the drone features several modes which make flying more enjoyable.
The Altair Outlaw takes a microSD TF memory card. No memory card is included with the Altair Outlaw SE.
The Altair Outlaw SE features 6 axis control. This means that the drone can go up and down, left and right, and it can also turn clockwise and counterclockwise.
The Altair Outlaw SE does have Headless Mode.
Make sure that you are outside and in and open space with a low amount of wind before you unlock your drone. First, be sure that your drone has the battery in and compass calibration has been completed and that your drone is paired with the remote. Next, to unlock the propellers, short-press the red button on the top right of your controller. Your drone is now ready for flight! Take a look at this video to see this process.
The Return-to-Home Function on the Outlaw SE will bring your drone back to it's starting point automatically. You can push a button to bring the drone back but return-to-home will also enable itself if the drone battery is low or if the drone loses signal. Watch this video for more information.
Gesture mode does not use the GPS functionality of your Altair Outlaw SE. This is a more advanced setting and should only be used by experienced pilots. Please see this video to understand the differences between gesture mode and GPS mode.
Aircraft compass calibration should be done each time the battery has been removed and then reinserted into the drone. Take a look atthis video to see how to compass calibration works.
No. Please do not leave any charging batteries outside of your care and never leave them to charge overnight. Take a look at this video for more information.
Yes! Use the included smartphone attachment to use your smartphone for FPV viewing. Take a look at this video for FPV fliying in action